#Cleaning out a sewage ejector system how to

The impeller is a critical component of the pump that moves the wastewater through the system and out to the sewer. If any of these components look damaged or worn, replacing them with new parts may be necessary. Check the electric wire connection and wiring diagram to ensure they are correct.Īlso, check the insulation on the power and switch connection for signs of wear and tear. The power and switch connection should be checked to ensure that it is properly connected and that there are no loose or broken wires.

#Cleaning out a sewage ejector system how to

The power and switch connection, impeller, motor, float switch, and check valve are all components that can wear down over time and experience various types of damage.Īs such, it is important to know how to inspect these parts for damage and how to replace them if necessary. When inspecting a sewage ejector pump, there are several crucial internal parts that one should carefully examine. Step 04: Inspection and Replacement of Damaged Pump Parts

Remember to take pictures or mark the position of the pipes to avoid any confusion when reconnecting them later.Īfter removing the bolts or screws, gently lift the pump out of the basin, not damaging the float switch or other electrical components. You may need to use a pry bar or other tools to loosen the pump.īefore removing the pump, it is essential to note the position of the discharge, vent, and inlet pipes. Depending on the design of the pump, this may involve removing bolts or screws that hold the pump in place. The next step is to remove the sewage ejector pump from the basin. Ensure a bucket or tray is under to catch any water or sewage that may spill out. If the pipes are corroded and difficult to remove, use a pipe cutter to cut the pipe near the pump. Begin by loosening the nuts that secure the pipes to the pump, then gently pull the pipes out of the pump. It is essential to wear protective gloves when handling pipes as they may be sharp or corroded, causing injury to your hands. You will need to remove the pipes that connect to the sewage ejector pump, which may require using a wrench or pliers. Once the power is off, it is time to disconnect the plumbing. Tagging or marking the breaker is essential so other individuals do not accidentally switch it back on.īefore proceeding, make sure to check that the power is off by using a voltage meter. If you opt to shut off the circuit breaker, locate the circuit breaker panel and turn off the pump’s circuit breaker. If you choose to unplug the pump, locate the plug and gently pull it out of the socket. You can unplug the ejector pump or shut off the circuit breaker that supplies power to the pump. There are two methods of turning off the power supply. Here are the steps you should follow: Step 01: Turn Off the Power Supply Steps on How to Fix a Sewage Ejector Pumpįixing a sewage ejector pump can be challenging, and it is important to proceed carefully to avoid further damage or injury.

Master the Art of Sewage Ejector Pump Repair.

What causes an ejector pump not to build pressure?.

What causes an ejector pump to stop working?.

Step 08: Restore Power and Test the Pump.

Step 04: Inspection and Replacement of Damaged Pump Parts.

Step 03: Remove the Pump from the Basin.Steps on How to Fix a Sewage Ejector Pump.